Castle Auto Enterprises

E.F.I. Wiring Kits - Chev Vortec

vortec3.jpg (20715 bytes)

E.F.I. Wiring Kits for Chev Vortec V8 Engine.

Kit Description:
This Set-Up is programmed to run on Premium Unleaded Fuel

We have a Complete Engine Management Kit to suit these engines utilising the factory manifold set-up. The kit comes with all parts required: - G.M. Delco reprogrammed PCM, new distributor, MAF Sensor, Oxy sensors, engine and control wiring loom (requires only 6 wire connection), Temp sensor, weld in oxy sensor bungs and coil. Please specify the vehicle application when ordering or contact us for more information. (Extractors shown in picture also available separately)

LOOMEFI-20 Engine Management loom to suit Chev Vortec Engines $1100 c/o

*Please Advise on Transmission Application

GM-16234531 Delco ECM.Sequential type.Suit V8 VT Comm. $350 c/o

MEMCAL-VORTEC Memcal re-programed to suit Chev Vortec engines $660

DIST-2 Distributor to suit sequential firing. Chev & Ford Application $550

LOOMS/S-02 Speed Sensor assembly & Loom with speedo cable provision. Suit T-350-400. Powerglide Auto Trans. $200

MEC-718 Ignition Coil $80

37016 Ignition Module suit Holden Commodore V8 VN-VP-VR-VS-VT $275 Single click for Image.

B0280130026 Temp Sender. $25

VDO231.088 OIL PRESSURE SENDER $25.00

GM-12160245 Manifold Air Temperatuer Sensor $17

B0580464070 Hi-pressure EFI fuel pump $195 Single click for Image.

BF-5030 Hi-pressure fuel filter $20 Single click for Image.

ST-4 EFI Surge Tank $150 Single click for Image.

10229 EFI Fuel Pump. Includes swirl pot. In-tank application to be used with GENIII-WELD RING $250 Single click for Image.
10229 Holden Commodore VT 5Ltr & V6 In-tank Fuel Pump Assembly. $255 Single click for Image.

Error - No Match for G/R-1/1.9

Please Note - Prices Can Vary Depending On Transmission Application
All Prices in $Au including GST. Overseas orders will be lower. 
Back to the EFI wiring page

-